Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
test-and-measurement:guides:waveforms-impedance-analyzer [2023/02/23 20:31] – Martha | test-and-measurement:guides:waveforms-impedance-analyzer [2024/02/29 14:25] (current) – [Using the Impedance Analyzer] replaced image Fausto Soares | ||
---|---|---|---|
Line 3: | Line 3: | ||
~~TechArticle~~ | ~~TechArticle~~ | ||
- | {{reference:test-and-measurement:analog-discovery-studio: | + | {{test-and-measurement/analog-discovery-pro-2230/impedance-screenshot.png?nolink|}} |
===== Introduction ===== | ===== Introduction ===== | ||
Line 11: | Line 11: | ||
===== Prerequisites ===== | ===== Prerequisites ===== | ||
* Digilent Test and Measurement Device with Analog Inputs and Outputs: | * Digilent Test and Measurement Device with Analog Inputs and Outputs: | ||
+ | * [[test-and-measurement: | ||
* [[test-and-measurement: | * [[test-and-measurement: | ||
* [[test-and-measurement: | * [[test-and-measurement: | ||
+ | * [[test-and-measurement: | ||
* [[test-and-measurement: | * [[test-and-measurement: | ||
* [[test-and-measurement: | * [[test-and-measurement: | ||
Line 18: | Line 20: | ||
* Computer with WaveForms Software Installed | * Computer with WaveForms Software Installed | ||
* A Reference Circuit, which can be provided by: | * A Reference Circuit, which can be provided by: | ||
- | * [[https:// | + | * [[https:// |
* [[https:// | * [[https:// | ||
* A reference resistor appropriate for the specific load, as described in [[# | * A reference resistor appropriate for the specific load, as described in [[# | ||
Line 108: | Line 110: | ||
---- | ---- | ||
<WRAP group> <WRAP column half> | <WRAP group> <WRAP column half> | ||
- | The Impedance Analyzer Adapter attaches to the MTE cable connector slot on the Analog Discovery | + | The Impedance Analyzer Adapter attaches to the MTE cable connector slot on the Analog Discovery. A load, whether a single component, or a circuit to test, should be connected to connector J2, and the component or jumpers should be locked in place with the orange clips. |
</ | </ | ||
{{ : | {{ : |