Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
test-and-measurement:analog-discovery-pro-5250:reference-manual [2021/10/04 23:20] – [WaveForms Software Development Kit (SDK)] Andrew Holzer | test-and-measurement:analog-discovery-pro-5250:reference-manual [2022/10/05 15:57] (current) – changed 'Scopes and Instruments' to 'Test and Measurement' Fausto Soares | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Analog Discovery Pro 5250 Reference Manual ====== | + | ====== Analog Discovery Pro (ADP5250) |
~~TechArticle~~ | ~~TechArticle~~ | ||
/*| image = {{ : | /*| image = {{ : | ||
Line 5: | Line 6: | ||
{{Digilent Image Gallery | {{Digilent Image Gallery | ||
- | | image = {{ :reference: | + | | image = {{ : |
- | | image = {{:reference: | + | | image = {{ : |
- | | image = {{ : | + | | image = {{ : |
- | | image = {{ :reference: | + | | image = {{ : |
- | | image = {{ :reference: | + | |
- | | image = {{ : | + | |
- | | image = {{ : | + | |
- | | image = {{ : | + | |
- | | image = {{ : | + | |
- | | image = {{ : | + | |
- | | image = {{ : | + | |
- | | image = {{ : | + | |
- | | image = {{ : | + | |
- | | image = {{ : | + | |
- | | image = {{ : | + | |
- | | image = {{ : | + | |
- | }} | + | |
+ | | image = {{: | ||
+ | | image = {{: | ||
+ | | image = {{: | ||
+ | | image = {{: | ||
+ | | image = {{: | ||
+ | | image = {{: | ||
+ | | image = {{: | ||
+ | | image = {{: | ||
+ | | image = {{: | ||
+ | | image = {{: | ||
+ | | image = {{: | ||
+ | }} | ||
===== Oscilloscope ===== | ===== Oscilloscope ===== | ||
- | {{reference: | + | {{: |
- | The Analog Discovery Pro ADP5250 can be used with WaveForms’ Oscilloscope instrument to capture analog data via the 2 analog input (“Scope”) | + | The Analog Discovery Pro (ADP5250) can be used with WaveForms’ Oscilloscope instrument to capture analog data via the 2 analog input channels using BNC probes. |
Since the Analog Discovery Pro’s analog input channels are shared, the Oscilloscope instrument cannot be used at the same time as the Spectrum Analyzer, Network Analyzer, or Impedance Analyzer instruments. | Since the Analog Discovery Pro’s analog input channels are shared, the Oscilloscope instrument cannot be used at the same time as the Spectrum Analyzer, Network Analyzer, or Impedance Analyzer instruments. | ||
+ | |||
+ | The Analog Discovery Pro features an additional connector, found just to the right of the analog input channels, that provides a square wave for use in compensating your probes. By connecting the probe to the tab indicated by the square wave symbol and the ground clip to the tab indicated by the ground symbol, a 5 V, 1 kHz, square wave reference signal can be measured using the Scope instrument. If your probes support adjusting the compensation, | ||
For more information on the analog input (" | For more information on the analog input (" | ||
Line 45: | Line 46: | ||
* Captured data files can be exported in standard formats | * Captured data files can be exported in standard formats | ||
* Scope configurations can be saved, exported, and imported | * Scope configurations can be saved, exported, and imported | ||
+ | * Front panel connector generating a 5 V, 1 kHz, square wave for convenient compensation of BNC oscilloscope probes | ||
---- | ---- | ||
===== Waveform Generator ===== | ===== Waveform Generator ===== | ||
- | {{reference: | + | {{: |
- | The Analog Discovery Pro ADP5250 can be used with WaveForms' | + | The Analog Discovery Pro (ADP5250) can be used with WaveForms' |
- | The waveform generator channel is considered a single ended pin, however, a connected circuit must share a ground with the Analog Discovery Pro. The channel has a bandwidth of >15MHz through the BNC connector. AC amplitudes of +-6V and DC offsets of +-6V are supported. | + | The waveform generator channel is considered a single ended pin, however, a connected circuit must share a ground with the Analog Discovery Pro. |
Since the Analog Discovery Pro's analog output channel is shared, the Waveform Generator instrument cannot be used at the same time as the Network Analyzer, or Impedance Analyzer instruments. | Since the Analog Discovery Pro's analog output channel is shared, the Waveform Generator instrument cannot be used at the same time as the Network Analyzer, or Impedance Analyzer instruments. | ||
Line 66: | Line 68: | ||
===== Power Supplies ===== | ===== Power Supplies ===== | ||
- | {{: | + | {{: |
- | The Analog Discovery Pro 5250 has 3 programmable Digital Voltage Supplies, which can supply between | + | The Analog Discovery Pro (ADP5250) |
- | For more information on using the programmable power supplies, please visit the [[test-and-measurement: | + | Each of the power supply rails is associated with an LED available on the connector, just above the supply' |
+ | |||
+ | For more information on using the programmable power supplies, please visit the [[test-and-measurement: | ||
==== Features ==== | ==== Features ==== | ||
* Three programmable power supplies | * Three programmable power supplies | ||
- | * 0V to 6V (0 A to 1 A) | + | * 0 V to 6 V (0 A to 1 A) |
- | * 0V to +25V (0 mA to 500 mA) | + | * 0 V to +25 V (0 mA to 500 mA) |
- | * 0V to -25V (0 mA to 500 mA) | + | * 0 V to -25 V (0 mA to 500 mA) |
* Up to 1A output current | * Up to 1A output current | ||
+ | |||
+ | ---- | ||
+ | ===== Data Logger ===== | ||
+ | |||
+ | {{: | ||
+ | |||
+ | The Analog Discovery Pro (ADP5250) can be used with WaveForms' | ||
+ | |||
+ | The Data Logger can capture buffers of data at update rates of up to 10 samples per second. The maximum duration of a log is dependent on the update rate, but at the extreme, can run for over a thousand hours. | ||
+ | |||
+ | Since the Analog Discovery Pro's analog input channels are shared, the Data Logger instrument cannot be used at the same time as the Oscilloscope, | ||
+ | |||
+ | For more information on the analog input (" | ||
+ | |||
+ | ==== Features ==== | ||
+ | * Measurements: | ||
+ | * Up to 24 hours of data logged at a 1 Hz sample rate | ||
+ | * Scriptable conversion functions | ||
---- | ---- | ||
===== Logic Analyzer ===== | ===== Logic Analyzer ===== | ||
- | {{reference: | + | {{: |
- | The Analog Discovery Pro 5250 can be used with WaveForms' | + | The Analog Discovery Pro (ADP5250) |
Individual input/ | Individual input/ | ||
Line 104: | Line 126: | ||
===== Static I/O ===== | ===== Static I/O ===== | ||
- | {{reference: | + | {{: |
- | The Analog Discovery Pro 5250 can be used with WaveForms' | + | The Analog Discovery Pro (ADP5250) |
- | **Important Note:** //To prevent damage to the device, care must be taken not to drive input signals to the digital input/ | + | **Important Note:** //To prevent damage to the device, care must be taken not to drive input signals to the digital input/ |
Digital input/ | Digital input/ | ||
- | For more information on the digital input/ | + | For more information on the digital input/ |
==== Features ==== | ==== Features ==== | ||
Line 121: | Line 143: | ||
===== Spectrum Analyzer ===== | ===== Spectrum Analyzer ===== | ||
- | {{reference: | + | {{: |
- | The Analog Discovery Pro 5250 can be used with WaveForms' | + | The Analog Discovery Pro (ADP5250) |
- | Signals | + | Signals can be plotted in units of peak voltage, RMS voltage, and various voltage level ratio units. |
Since the Spectrum Analyzer instrument uses the same hardware resources as the Oscilloscope, | Since the Spectrum Analyzer instrument uses the same hardware resources as the Oscilloscope, | ||
Line 142: | Line 164: | ||
---- | ---- | ||
===== Network Analyzer ===== | ===== Network Analyzer ===== | ||
- | {{reference: | ||
- | The Analog Discovery Pro 5250 can be used with WaveForms' | + | {{: |
+ | |||
+ | The Analog Discovery Pro (ADP5250) | ||
Frequency sweeps can be performed in ranges between 1 mHz and 10 MHz with up to 10k samples per decade. The wave used for the sweep can be customized, and uses the same resources as the Waveform Generator instrument. | Frequency sweeps can be performed in ranges between 1 mHz and 10 MHz with up to 10k samples per decade. The wave used for the sweep can be customized, and uses the same resources as the Waveform Generator instrument. | ||
- | The Network Analyzer instrument uses the analog output and analog input channels of the Analog Discovery Pro 5250 to probe a test circuit. The Network Analyzer can be configured to use an external signal to provide input to the circuit under test, rather than using the analog output channels. | + | The Network Analyzer instrument uses the analog output and analog input channels of the Analog Discovery Pro (ADP5250) |
- | Since the Analog Discovery Pro's analog input and output channels are shared, the Network Analyzer instrument cannot be used at the same time as the Oscilloscope, | + | Since the Analog Discovery Pro's analog input and output channels are shared, the Network Analyzer instrument cannot be used at the same time as the Oscilloscope, |
For more information on the analog output and analog input channels, please visit the [[test-and-measurement: | For more information on the analog output and analog input channels, please visit the [[test-and-measurement: | ||
Line 162: | Line 185: | ||
===== Impedance Analyzer ===== | ===== Impedance Analyzer ===== | ||
- | {{reference: | + | {{: |
- | The Analog Discovery Pro 5250 can be used with WaveForms' | + | The Analog Discovery Pro (ADP5250) |
- | Frequency sweeps | + | Frequency sweeps |
The Impedance Analyzer instrument uses the Analog Discovery Pro's analog output channels and analog input channels to probe a test circuit. | The Impedance Analyzer instrument uses the Analog Discovery Pro's analog output channels and analog input channels to probe a test circuit. | ||
- | Since the Analog Discovery Pro's analog input and output channels are shared, the Impedance Analyzer instrument cannot be used at the same time as the Oscilloscope, | + | Since the Analog Discovery Pro's analog input and output channels are shared, the Impedance Analyzer instrument cannot be used at the same time as the Oscilloscope, |
For more information on the analog output and analog input channels, please visit the [[test-and-measurement: | For more information on the analog output and analog input channels, please visit the [[test-and-measurement: | ||
Line 182: | Line 205: | ||
---- | ---- | ||
===== WaveForms Script Editor ===== | ===== WaveForms Script Editor ===== | ||
- | {{reference: | + | {{: |
Each of WaveForms' | Each of WaveForms' | ||
- | A variety of code examples are available in the application to aid in learning to write WaveForms scripts. Additional resources for writing scripts can be found on the Scopes | + | A variety of code examples are available in the application to aid in learning to write WaveForms scripts. Additional resources for writing scripts can be found on the Test and Measurement |
A plot pane within the Script instrument itself can be used to integrate data from many different instruments, | A plot pane within the Script instrument itself can be used to integrate data from many different instruments, | ||
Line 208: | Line 231: | ||
* Provides control of hardware channels and virtual instruments to custom applications | * Provides control of hardware channels and virtual instruments to custom applications | ||
- | **Note: | + | **Note:** For custom |
---- | ---- |