Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| programmable-logic:cmod-a7:reference-manual [2023/08/03 19:53] – [4 Quad-SPI Flash] Arthur Brown | programmable-logic:cmod-a7:reference-manual [2024/01/06 00:22] (current) – [4 Quad-SPI Flash] Arthur Brown | ||
|---|---|---|---|
| Line 142: | Line 142: | ||
| //Figure 4.1. Cmod A7 Quad-SPI Flash// | //Figure 4.1. Cmod A7 Quad-SPI Flash// | ||
| - | In manufacturing, | + | Due to a component for the Cmod A7 going end-of-life, your board may feature one of several different Quad SPI Flash parts. The Quad SPI Flash memory on any particular Cmod A7 can be found in Table 4.1 below. To determine which part is used by a particular board, look at the part number printed on IC3 on the top of the Cmod A7 (See Figure 4.2). Datasheets for each flash part can be found on their respective manufacturer' |
| When using Vivado to program the flash, the part number of the flash on the board that is being programmed must be known. See Table 4.1. | When using Vivado to program the flash, the part number of the flash on the board that is being programmed must be known. See Table 4.1. | ||
| Line 160: | Line 160: | ||
| //Table 4.1 Cmod A7 Flash parts// | //Table 4.1 Cmod A7 Flash parts// | ||
| - | |<50%>| | + | |<70%>| |
| - | ^ Manufacturer | + | ^ Manufacturer |
| - | | Micron | + | | Micron |
| - | | Macronix | + | | Macronix |
| ---- | ---- | ||