Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
pmod:pmoddpg1:start [2022/09/13 14:46] – changed forum.digilentinc.com to forum.digilent.com Jeffreypmod:pmoddpg1:start [2024/04/02 19:46] (current) – Martha
Line 1: Line 1:
 +~~NOTOC~~ 
 +   
 +====== Pmod DPG1 ======
 +  
 +{{Digilent Infobox
  
 +| Manual = [[reference-manual]]
 +| Support = https://forum.digilent.com/forum/7-add-on-boards/
 +| Title = Pmod DPG1
 +| Subtitle = Differential Pressure Gauge Sensor
 +| Header = Features
 +| Bullet = Differential pressure gauge transducer
 +| Bullet = 12-bit ADC
 +| Bullet = 0 to 10 %%kPa%% differential pressure range
 +| Bullet = Temperature compensated and calibrated
 +| Bullet = 6-pin Pmod connector with SPI interface
 +| Bullet = Follows the Digilent {{/reference/pmod/digilent-pmod-interface-specification.pdf |Pmod Interface Specification}} Type 2
 +| Header = Electrical
 +| Bus = [[learn/fundamentals/communication-protocols/spi/start | SPI]]
 +| Specification Version = 1.2.0
 +| Logic Level = 3.3V
 +| Header = Physical
 +| Width = 1.0 in (2.54 cm)
 +| Length = 0.8 in (2.0 cm)
 +| Header = Design Resources
 +| 3D CAD Model = {{:reference:pmod:pmoddpg1:pmod_dpg1.zip| }}
 +| Header = Documentation
 +| Primary IC = [[http://www.nxp.com/files/sensors/doc/data_sheet/MP3V5010.pdf| MP3V5010DP]], [[http://www.ti.com/lit/ds/symlink/adcs7476.pdf| ADCS7476]]
 +| Reference Manual = [[pmod/pmoddpg1/reference-manual]]
 +| Schematic = {{:reference:pmod:pmoddpg1:pmoddpg1_sch.pdf| }}
 +| Header = J1 Pinout
 +| Full Row = {{ :reference:pmod:pmod-pinout-1x6.png?direct |}}
 +| Pin 1 = SS
 +| Pin 2 = NC
 +| Pin 3 = MISO
 +| Pin 4 = SCK
 +| Pin 5 = GND
 +| Pin 6 = VCC
 +}}
 +
 +
 +{{page>reference-manual}} 
 +\\
 +\\
 +\\
 +\\
 +\\
 +\\
 +\\
 +\\
 +
 +
 +
 +===== Example Projects =====
 +
 +==Microprocessor==
 +  * {{:reference:pmod:pmoddpg1:pmoddpg1_library_and_demo.zip|Library and MPIDE Example}}
 +  * [[learn/software/tutorials/digilent-core-install/start | Installing the Digilent Core for Arduino]]
 +  * [[https://www.hackster.io/mmigs/using-the-pmod-dpg1-with-arduino-uno-2456fe|Using the Pmod DPG1 with Arduino Uno]] - Application note
 +
 +== Programmable Logic==
 +  * [[learn/programmable-logic/tutorials/pmod-ips/start | Getting Started with Digilent Pmod IPs]]
 +    * Digilent Pmod IPs are only supported in Vivado and Xilinx SDK versions 2019.1 and earlier.
 +
 +----
 +
 +===== Additional Resources =====
 +  * Specification Version 1.2.0: {{reference/pmod/pmod-interface-specification-1_2_0.pdf |PDF}}
 +
 +----
 +
 +{{tag>pmod pmod-start pmod-spi pmoddpg1 differential-pressure-gauge resource-center}}