Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
pmod:pmodble:start [2022/09/13 17:44] – changed forum.digilentinc.com to forum.digilent.com Jeffreypmod:pmodble:start [2022/10/19 15:47] (current) – Updated regulatory approval link James Colvin
Line 1: Line 1:
 +~~NOTOC~~ 
 +   
 +====== Pmod BLE ======
 +  
 +{{Digilent Infobox
 +| Store Page = https://digilent.com/shop/pmod-ble-bluetooth-low-energy-interface/
 +| Manual = [[reference-manual]]
 +| Support = https://forum.digilent.com/forum/7-add-on-boards/
 +| Title = Pmod BLE
 +| Subtitle = Bluetooth Interface
 +| Header = Features
 +| Bullet = Fully Qualified Bluetooth® Low Energy Module
 +| Bullet = On-Board Bluetooth 4.2 Low Energy Stack
 +| Bullet = Certified to FCC, IC, CE, KCC, NCC and SRRC
 +| Bullet = ASCII Command Interface API
 +| Bullet = Secure communication AES128 Encryption
 +| Bullet = Remote Configuration Over The Air
 +| Bullet = Small PCB size for flexible designs 1.0" x 0.8" (2.57 cm × 2.03 cm)
 +| Bullet = 12-pin Pmod connector with UART interface
 +| Bullet = Follows Digilent Pmod Interface Specification Type 3A
 +| Header = Electrical
 +| Bus = [[learn/fundamentals/communication-protocols/uart/start | UART]]
 +| Specification Version = 1.2.0
 +| Logic Level = 3.3V
 +| Header = Physical
 +| Width = 1.5 in (3.81 cm)
 +| Length = 0.80 in (2.03 cm)
 +| Header = Documentation
 +| Primary IC = [[http://www.microchip.com/wwwproducts/en/RN4871 | RN4871]]
 +| Reference Manual = [[pmod/pmodble/reference-manual]]
 +| Schematic = {{:reference:pmod:pmodble:pmodble_sch.pdf| }}
 +| Header = J1 Pinout
 +| Full Row = {{ :reference:pmod:pmod-pinout-2x6.png?direct |}}
 +| Pin 1 = RTS
 +| Pin 2 = RXD
 +| Pin 3 = TXD
 +| Pin 4 = CTS
 +| Pin 5 = GND
 +| Pin 6 = VCC
 +| Pin 7 = GPIO
 +| Pin 8 = RST_N
 +| Pin 9 = MODE
 +| Pin 10 = STATUS
 +| Pin 11 = GND
 +| Pin 12 = VCC
 +| Header = Product Compliance
 +| HTC = 8517620090
 +| ECCN = 5A992.c
 +}}
  
 +{{page>reference-manual}} \\ \\
 +
 +===== Example Projects =====
 +==Microprocessor ==
 +  * [[learn/software/tutorials/digilent-core-install/start | Installing the Digilent Core for Arduino]]
 +  * {{:reference:pmod:pmodble:pmodble-arduino-library.zip|Library and Arduino Example}}
 +
 +==Programmable Logic==
 +  * [[learn/programmable-logic/tutorials/pmod-ips/start | Getting Started with Digilent Pmod IPs]]
 +    * Digilent Pmod IPs are only supported in Vivado and Xilinx SDK versions 2019.1 and earlier.
 +
 +----
 +
 +===== Additional Resources =====
 +  * Specification Version 1.2.0: {{reference/pmod/pmod-interface-specification-1_2_0.pdf |PDF}}
 +  * {{:reference:pmod:pmodble:rn4871_user_guide.pdf |RN4871 User Guide}}
 +  * [[https://www.microchip.com/en-us/product/RN4871#document-table|RN4871 Regulatory Approval Documentation from Microchip]]
 +
 +----
 +
 +
 +{{tag>pmod pmod-start pmod-uart pmodble bluetooth resource-center}}