Pmod BLE

Buy Reference Manual Technical Support
Pmod BLE
Bluetooth Interface
Features
  • Fully Qualified Bluetooth® Low Energy Module
  • On-Board Bluetooth 4.2 Low Energy Stack
  • Certified to FCC, IC, CE, KCC, NCC and SRRC
  • ASCII Command Interface API
  • Secure communication AES128 Encryption
  • Remote Configuration Over The Air
  • Small PCB size for flexible designs 1.0“ x 0.8” (2.57 cm × 2.03 cm)
  • 12-pin Pmod connector with UART interface
  • Follows Digilent Pmod Interface Specification Type 3A
Electrical
Bus
UART
Specification Version
1.2.0
Logic Level
3.3V
Physical
Width
1.5 in (3.81 cm)
Length
0.80 in (2.03 cm)
Documentation
Primary IC
RN4871
Reference Manual
Pmod BLE Reference Manual
Schematic
J1 Pinout
Pin 1
RTS
Pin 2
RXD
Pin 3
TXD
Pin 4
CTS
Pin 5
GND
Pin 6
VCC
Pin 7
GPIO
Pin 8
RST_N
Pin 9
MODE
Pin 10
STATUS
Pin 11
GND
Pin 12
VCC
Product Compliance
HTC
8517620090
ECCN
5A992.c

The Digilent Pmod BLE (Revision A) is a powerful peripheral module meant for use with any UART enabled development board. This Pmod employs the Roving Networks RN4871 to create a fully integrated Bluetooth Low Energy interface. This chip features an onboard Bluetooth stack that makes connecting and communicating with any Bluetooth 4.0+ device possible through simple UART commands. The RN4871 also features four built in GATT services: Device Information, Airpatch, BeaconThings, and UART Transparent data streaming. It also allows up to five custom public services and up to 4 custom private services, each allowing up to eight custom characteristics. The PmodBLE is a cheap, versatile, low energy addition to the wireless Pmod library.



Example Projects

Microprocessor
Programmable Logic

Additional Resources

, , , , ,