Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
vivado:getting-started-with-ipi:start [2019/10/31 21:23] – Arthur Brown | vivado:getting-started-with-ipi:start [2021/02/11 16:25] – Arthur Brown | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Getting Started with Vivado IP Integrator ====== | ====== Getting Started with Vivado IP Integrator ====== | ||
+ | |||
+ | <WRAP center round important 60%> | ||
+ | This guide uses 2016.4. An updated version of this guide for 2018.2 can be found [[/ | ||
+ | </ | ||
+ | |||
/*FIXME: images should be collected into the correct namespace (yay)*/ | /*FIXME: images should be collected into the correct namespace (yay)*/ | ||
Line 315: | Line 320: | ||
Click **Run Block Automation** in the green bar at the top of the screen. This will launch a dialog that allows initial configuration of the Zynq block. | Click **Run Block Automation** in the green bar at the top of the screen. This will launch a dialog that allows initial configuration of the Zynq block. | ||
- | In the Run Block Automation dialog, make sure that **FIXME** under **All Automation** in the panel to the left is selected and checked. | + | In the Run Block Automation dialog, make sure that **Apply Board preset** under **All Automation** in the panel to the left is checked. |
There are a number of different options available. For the purposes of this guide, set these options to the value found in parentheses below. | There are a number of different options available. For the purposes of this guide, set these options to the value found in parentheses below. | ||
Line 889: | Line 894: | ||
----- | ----- | ||
- | {{tag> | + | {{tag> |