Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
vivado:getting-started-with-ipi:2018.2 [2018/08/06 23:39] – [9. Receiving Messages over UART] Arthur Brownvivado:getting-started-with-ipi:2018.2 [2019/12/16 22:00] – [4. Create a Simple Block Design] Arthur Brown
Line 12: Line 12:
     * //See the [[:vivado:installing-vivado:2018.2|Installing Vivado and Digilent Board Files]] tutorial for more information.//     * //See the [[:vivado:installing-vivado:2018.2|Installing Vivado and Digilent Board Files]] tutorial for more information.//
   * **Serial Terminal Emulator Program**   * **Serial Terminal Emulator Program**
-    *  //See the [[FIXME|Using a Serial Terminal Emulator]] tutorial for more information.//+    *  //See the [[:learn/programmable-logic/tutorials/tera-term|Using a Serial Terminal Emulator]] tutorial for more information.//
  
  
Line 432: Line 432:
 In the Run Connection Automation dialog's list pane, make sure that the S_AXI entry is checked and selected. In the Run Connection Automation dialog's list pane, make sure that the S_AXI entry is checked and selected.
  
-In the options pane to the right of the dialog, the clock source to run the AXI bus connecting the GPIO IP to the Zynq block can be selected. Select **/processing_system7_0/FCLK_CLK0** from the drop-down list.+In the options pane to the right of the dialog, the clock source to run the AXI bus connecting the GPIO IP to the Zynq block can be selected. Select **/processing_system7_0/FCLK_CLK0** from each drop-down list.
  
 Click **OK** to continue. Click **OK** to continue.