Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
test-and-measurement:analog-discovery-pro-3x50:connect-to-the-internet [2021/05/14 23:08] – ↷ Links adapted because of a move operation Arthur Browntest-and-measurement:analog-discovery-pro-3x50:connect-to-the-internet [2023/10/18 19:25] (current) – Alyssa Holzer
Line 8: Line 8:
   * Analog Discovery Pro in Linux mode   * Analog Discovery Pro in Linux mode
     * If you haven't used Linux mode before, check out the [[linux-mode|Getting Started in Linux Mode]] guide for information on how to switch from the default Standard mode into Linux mode, boot into Linux, and connect to it with a serial terminal.     * If you haven't used Linux mode before, check out the [[linux-mode|Getting Started in Linux Mode]] guide for information on how to switch from the default Standard mode into Linux mode, boot into Linux, and connect to it with a serial terminal.
-  * A computer with [[https://mautic.digilentinc.com/waveforms-download|WaveForms]] installed, version 3.16.3 or later+  * A computer with [[https://cloud.digilent.com/myproducts/waveform?pc=1&tab=2|WaveForms]] installed, version 3.16.3 or later
   * USB cable   * USB cable
   * Ethernet cable or a USB WiFi Dongle (see the [[test-and-measurement:analog-discovery-pro-3x50:specifications#compatible_wi-fi_chipsets|Specifications]] for a list of compatible dongles)   * Ethernet cable or a USB WiFi Dongle (see the [[test-and-measurement:analog-discovery-pro-3x50:specifications#compatible_wi-fi_chipsets|Specifications]] for a list of compatible dongles)
Line 75: Line 75:
 You can observe the boot process with the previously-connected serial terminal. When it completes, a login prompt will be seen. You can observe the boot process with the previously-connected serial terminal. When it completes, a login prompt will be seen.
  
-Log into the device. By default, the username and password are both "//digilent//".+Once the device boots, log in using your username and password. The table below lists the defaults if you are using it for the first time: 
 + 
 +|<60% 60% 40%>| 
 +^ Default username: | digilent | 
 +^ Default password: | digilent |
  
 Note that upon login, a "urandom warning" may be printed to the terminal, and can safely be ignored. Note that upon login, a "urandom warning" may be printed to the terminal, and can safely be ignored.
Line 196: Line 200:
 Check out the [[start|Analog Discovery Pro (ADP3450/ADP3250) Resource Center]] for more guides on using your device. Check out the [[start|Analog Discovery Pro (ADP3450/ADP3250) Resource Center]] for more guides on using your device.
  
-For technical support, please visit the [[https://forum.digilentinc.com/forum/8-test-and-measurement/|Test and Measurement]] section of the Digilent Forums.+For technical support, please visit the [[https://forum.digilent.com/forum/8-test-and-measurement/|Test and Measurement]] section of the Digilent Forums.