Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
programmers:jtag-smt3:start [2022/09/12 11:04] – changed forum.digilentinc.com to forum.digilent.com Jeffrey | programmers:jtag-smt3:start [2023/08/16 17:05] (current) – added SoV James Colvin | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ~~NOTOC~~ | ||
+ | |||
+ | ====== JTAG-SMT3-NC Resource Center====== | ||
+ | {{Digilent Infobox | ||
+ | | Store Page = https:// | ||
+ | | Manual = [[reference-manual]] | ||
+ | | Support = https:// | ||
+ | | Title = JTAG-SMT3-NC | ||
+ | | Subtitle = Surface-mount Programming Module | ||
+ | | Header = Features | ||
+ | | Bullet = Small, complete, all-in-one JTAG programming/ | ||
+ | | Bullet = Compatible with Xilinx Tools | ||
+ | | Bullet = High-Speed USB 2.0 port that can drive JTAG bus up to 30Mbit/sec (frequency settable by user) | ||
+ | | Bullet = Open drain buffer on PS_SRST_B pin allows debugging software to reset the processor core of Xilinx’s Zynq® platform | ||
+ | | Bullet = Dual channel USB controller provides simultaneous access to both JTAG and UART interfaces | ||
+ | | Bullet = Separate Vref for JTAG and UART signals allows each interface to operate at difference voltages (1.8V to 5.5V) | ||
+ | | Bullet = Small form-factor surface-mount module can be directly loaded on target boards | ||
+ | | Bullet = USB D+ and D- signals routed to pads, allowing USB connector to be placed anywhere on the host PCB | ||
+ | | Bullet = VBUS_DETECT pin allows for reduced current consumption when the module isn’t connected to a PC | ||
+ | | Header = Product Compliance | ||
+ | | HTC = 8473301180 | ||
+ | | ECCN = EAR99 | ||
+ | |||
+ | }} | ||
+ | |||
+ | {{page> | ||
+ | |||
+ | ===== Documentation ===== | ||
+ | {{topic> | ||
+ | * {{: | ||
+ | * {{https:// | ||
+ | |||
+ | ---- | ||
+ | |||
+ | ===== Tutorials ===== | ||
+ | {{topic> | ||
+ | |||
+ | ---- | ||
+ | |||
+ | |||
+ | {{tag> |