Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Last revisionBoth sides next revision
pmod:pmodble:start [2022/02/15 21:02] – Keith M Kolmospmod:pmodble:start [2022/09/13 17:44] – changed forum.digilentinc.com to forum.digilent.com Jeffrey
Line 1: Line 1:
-~~NOTOC~~  
-    
-====== Pmod BLE ====== 
-   
-{{Digilent Infobox 
-| Store Page = https://digilent.com/shop/pmod-ble-bluetooth-low-energy-interface/ 
-| Manual = [[reference-manual]] 
-| Support = https://forum.digilentinc.com/forum/7-add-on-boards/ 
-| Title = Pmod BLE 
-| Subtitle = Bluetooth Interface 
-| Header = Features 
-| Bullet = Fully Qualified Bluetooth® Low Energy Module 
-| Bullet = On-Board Bluetooth 4.2 Low Energy Stack 
-| Bullet = Certified to FCC, IC, CE, KCC, NCC and SRRC 
-| Bullet = ASCII Command Interface API 
-| Bullet = Secure communication AES128 Encryption 
-| Bullet = Remote Configuration Over The Air 
-| Bullet = Small PCB size for flexible designs 1.0" x 0.8" (2.57 cm × 2.03 cm) 
-| Bullet = 12-pin Pmod connector with UART interface 
-| Bullet = Follows Digilent Pmod Interface Specification Type 3A 
-| Header = Electrical 
-| Bus = [[learn/fundamentals/communication-protocols/uart/start | UART]] 
-| Specification Version = 1.2.0 
-| Logic Level = 3.3V 
-| Header = Physical 
-| Width = 1.5 in (3.81 cm) 
-| Length = 0.80 in (2.03 cm) 
-| Header = Documentation 
-| Primary IC = [[http://www.microchip.com/wwwproducts/en/RN4871 | RN4871]] 
-| Reference Manual = [[pmod/pmodble/reference-manual]] 
-| Schematic = {{:reference:pmod:pmodble:pmodble_sch.pdf| }} 
-| Header = J1 Pinout 
-| Full Row = {{ :reference:pmod:pmod-pinout-2x6.png?direct |}} 
-| Pin 1 = RTS 
-| Pin 2 = RXD 
-| Pin 3 = TXD 
-| Pin 4 = CTS 
-| Pin 5 = GND 
-| Pin 6 = VCC 
-| Pin 7 = GPIO 
-| Pin 8 = RST_N 
-| Pin 9 = MODE 
-| Pin 10 = STATUS 
-| Pin 11 = GND 
-| Pin 12 = VCC 
-| Header = Product Compliance 
-| HTC = 8517620090 
-| ECCN = 5A992.c 
-}} 
  
-{{page>reference-manual}} \\ \\ 
- 
-===== Example Projects ===== 
-==Microprocessor == 
-  * [[learn/software/tutorials/digilent-core-install/start | Installing the Digilent Core for Arduino]] 
-  * {{:reference:pmod:pmodble:pmodble-arduino-library.zip|Library and Arduino Example}} 
- 
-==Programmable Logic== 
-  * [[learn/programmable-logic/tutorials/pmod-ips/start | Getting Started with Digilent Pmod IPs]] 
-    * Digilent Pmod IPs are only supported in Vivado and Xilinx SDK versions 2019.1 and earlier. 
- 
----- 
- 
-===== Additional Resources ===== 
-  * Specification Version 1.2.0: {{reference/pmod/pmod-interface-specification-1_2_0.pdf |PDF}} 
-  * {{:reference:pmod:pmodble:rn4871_user_guide.pdf |RN4871 User Guide}} 
-  * TELEC Certification: {{http://ww1.microchip.com/downloads/en/DeviceDoc/JRF%20Certificate_BM70BLES1FC2,RN4870.pdf | TELEC Certification}} 
- 
----- 
- 
- 
-{{tag>pmod pmod-start pmod-uart pmodble bluetooth resource-center}}