This is an old revision of the document!
High Current Adapter for NI myRIO
Overview
The High Current Adapter for NI myRIO allows you drive high power low speed currents using relays and open drain N-FET otputs trough MXP connector on your myRIO. The switched signals are connected with screw terminals. For open drains a power supply is needed.
Key Features:
- Supports 3V…16V power voltage(external power supply required)
- 4 Open drain outputs
- Continuous current:3.0A(25°C)/2.2A(85°C)
- Peak output current:4.1A(t<5s)
- 4 Standard 3 terminal relay outputs
- Common, Normally Closed, Normally Open
- Relay output max switching voltage:30V
- Rated current:1A
- 34-pin female breakout allowing direct access to signal pins
- Uses the myRIO Expansion Port(MXP) connector
Connector Pin-outs
Relay connectors :
| Signal | Description |
|---|---|
| NOx | Normal Open |
| NCx | Normal Close |
| COMx | Common terminal |
Open Drains :
| Signal | Description |
|---|---|
| ODx- | Open Drain negative terminal |
| ODx+ , PWR+ | Supply voltage (internally connected) |
| PWR- | Ground |