Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| learn:programmable-logic:tutorials:nexys-video-programming-guide:start [2023/04/13 20:44] – updated QSPI section based on customer correction James Colvin | learn:programmable-logic:tutorials:nexys-video-programming-guide:start [2023/04/13 20:47] (current) – [4. Programming the Nexys Video using a USB Flash drive or Micro SD Card] James Colvin | ||
|---|---|---|---|
| Line 150: | Line 150: | ||
| >4.6) Safely remove the USB device or Micro SD Card from your computer and plug it into the USB port on the Nexys Video. | >4.6) Safely remove the USB device or Micro SD Card from your computer and plug it into the USB port on the Nexys Video. | ||
| - | >4.7) Make sure your board is connected to your computer for power and turn on the Nexys Video. It should immediately begin writing the .bit file to the FPGA. | + | >4.7) Make sure your board is connected to your computer for power and turn on the Nexys Video. It should immediately begin writing the .bit file to the FPGA. You may have to press the red PROG button next to JP4 before the Nexys Video configures itself with the bitstream loaded on the attached storage device. |
| - | Once finished your board should function exactly as it did when programming it with JTAG. Whether you were aware or not you just successfully programmed your Nexys Video board two separate ways using the same .bit file. | + | Once finished your board should function exactly as it did when programming it with JTAG. Whether you were aware or not you just successfully programmed your Nexys Video board two separate ways using the same .bit file. |
| ----- | ----- | ||