Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
learn:programmable-logic:tutorials:arty-microblaze-base-system-design:start [2016/07/08 19:57] – created Sam K | learn:programmable-logic:tutorials:arty-microblaze-base-system-design:start [2017/05/31 17:05] (current) – Removed Tags Arthur Brown | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Arty Base System Design ====== | + | ====== Arty Microblaze |
{{: | {{: | ||
Line 27: | Line 27: | ||
===== Prerequisites ===== | ===== Prerequisites ===== | ||
- | |||
- | ===Skills=== | ||
- | * **Basic familiarity with Vivado** | ||
- | * //This experience can be found by walking through our " | ||
===Hardware=== | ===Hardware=== | ||
Line 37: | Line 33: | ||
===Software=== | ===Software=== | ||
- | * **Vivado Design Suite 2015.4** | + | * **Vivado Design Suite 2016.4** |
- | * //You must use this version or the project will not generate// | + | * //Newer versions can be used, but the procedure may vary slightly// |
- | | + | * Xilinx SDK 2016.4 must be included in the installation |
- | * **Xilinx SDK 2015.4** | + | * **Digilent Board Support Files for Vivado** |
- | + | * Follow the [[vivado: | |
- | === Board Support Files === | + | |
- | * **Arty Support Files** | + | |
- | * These files will describe GPIO interfaces on your board and make it easier to select your FPGA board and add GPIO IP blocks. | + | |
- | * Follow the Wiki guide: | + | |
----- | ----- | ||
Line 51: | Line 43: | ||
===== Downloads ===== | ===== Downloads ===== | ||
- | Arty Support Repository -- [[https:// | + | Arty Support Repository -- [[https:// |
------ | ------ | ||
Line 125: | Line 117: | ||
>The demo is running a simple blink on LED5. This behaves much like the arduino sketch blink. | >The demo is running a simple blink on LED5. This behaves much like the arduino sketch blink. | ||
- | {{tag> | + | /*{{tag> |