Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
vivado:getting_started_with_zynq:start [2017/10/11 19:27] – Arthur Brown | vivado:getting_started_with_zynq:start [2017/10/20 20:26] – Arthur Brown | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Getting Started with Zynq and the Vivado IP Integrator ====== | ====== Getting Started with Zynq and the Vivado IP Integrator ====== | ||
- | /*FIXME: action | + | <WRAP round important 660px> |
+ | === Important! === | ||
+ | This guide is obsolete, the updated guide can be found [[: | ||
+ | </WRAP> | ||
+ | |||
+ | {{:vivado: | ||
===== Prerequisites ===== | ===== Prerequisites ===== | ||
Line 380: | Line 385: | ||
</ | </ | ||
- | <WRAP group> | ||
- | <WRAP column half> | ||
- | === 5.9 === | ||
Since the target design for this guide requires no major changes to the Zynq block' | Since the target design for this guide requires no major changes to the Zynq block' | ||
- | </ | ||
- | <WRAP column half> | ||
- | </ | ||
- | </ | ||
==== 6. Add Peripherals ==== | ==== 6. Add Peripherals ==== | ||
Line 730: | Line 728: | ||
The project will now be running on the Zynq board, press the buttons to see the LEDs flip on and off. | The project will now be running on the Zynq board, press the buttons to see the LEDs flip on and off. | ||
- | {{tag> | + | /*{{tag> |