Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| test-and-measurement:guides:waveforms-impedance-analyzer [2023/02/23 20:31] – Martha | test-and-measurement:guides:waveforms-impedance-analyzer [2024/02/28 19:24] – [Prerequisites] James Colvin | ||
|---|---|---|---|
| Line 11: | Line 11: | ||
| ===== Prerequisites ===== | ===== Prerequisites ===== | ||
| * Digilent Test and Measurement Device with Analog Inputs and Outputs: | * Digilent Test and Measurement Device with Analog Inputs and Outputs: | ||
| + | * [[test-and-measurement: | ||
| * [[test-and-measurement: | * [[test-and-measurement: | ||
| * [[test-and-measurement: | * [[test-and-measurement: | ||
| + | * [[test-and-measurement: | ||
| * [[test-and-measurement: | * [[test-and-measurement: | ||
| * [[test-and-measurement: | * [[test-and-measurement: | ||
| Line 18: | Line 20: | ||
| * Computer with WaveForms Software Installed | * Computer with WaveForms Software Installed | ||
| * A Reference Circuit, which can be provided by: | * A Reference Circuit, which can be provided by: | ||
| - | * [[https:// | + | * [[https:// |
| * [[https:// | * [[https:// | ||
| * A reference resistor appropriate for the specific load, as described in [[# | * A reference resistor appropriate for the specific load, as described in [[# | ||
| Line 108: | Line 110: | ||
| ---- | ---- | ||
| <WRAP group> <WRAP column half> | <WRAP group> <WRAP column half> | ||
| - | The Impedance Analyzer Adapter attaches to the MTE cable connector slot on the Analog Discovery | + | The Impedance Analyzer Adapter attaches to the MTE cable connector slot on the Analog Discovery. A load, whether a single component, or a circuit to test, should be connected to connector J2, and the component or jumpers should be locked in place with the orange clips. |
| </ | </ | ||
| {{ : | {{ : | ||