Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
software:daq-hats:start [2023/07/20 02:48] – Arthur Brown | software:daq-hats:start [2023/07/21 16:30] (current) – [Q&A] Martha | ||
---|---|---|---|
Line 33: | Line 33: | ||
< | < | ||
- | --> | + | --> |
I am trying to install a MCC118 onto a raspberry Pi 3. during the stage of running the " | I am trying to install a MCC118 onto a raspberry Pi 3. during the stage of running the " | ||
> "Error entering the bootloader” is what you see if you have the jumper set for board 1 (for example) and you call “mcc118_firmware_update 0 MCC_118.hex”. The “0” would need to be changed to agree with your address jumper. If you changed the jumper position (or plan to), be sure to power down. After the jumper is set to the desired position, power on (i.e. boot), then run sudo daqhats_read_eeproms (per installation instructions), | > "Error entering the bootloader” is what you see if you have the jumper set for board 1 (for example) and you call “mcc118_firmware_update 0 MCC_118.hex”. The “0” would need to be changed to agree with your address jumper. If you changed the jumper position (or plan to), be sure to power down. After the jumper is set to the desired position, power on (i.e. boot), then run sudo daqhats_read_eeproms (per installation instructions), |