2x6 Pin Pmod Cable

(1 review) Write a Review
Adding to cart… The item has been added

This 6" 2x6 pin cable allows users to connect a Pmod to a system board while conserving board space on the host.

  • Designed to connect a 12-pin Pmod to a 12-pin system board connector
  • Can be used to send Digilent System board signals to and from outside devices
  • Uses standard 100mil-spaced 25mil square connectors
  • 6" (15cm) in length
  • Includes one 12-pin gender changer

1 Review Hide Reviews Show Reviews

  • 3
    Gets the job done but one big annoyance

    Posted by David L. on 25th Feb 2017

    Maybe I'm going nuts, but the one thing I need to know about this jumper cable that isn't at all obvious when looking at it: what's the end-to-end pin orientation?? I don't always have a multimeter handy, so it would be really nice if the heatshrink or connector face had something to indicate pin 1 or otherwise tell me which given pin goes with which between the two ends. I realize there are any number of ways to test the pins to find out, but I really don't want to have to do that every single time, and the heatshrink doesn't show marks very well so even if I take the time to figure out the orientation, it's hard to mark the connectors. I could be completely missing something that's already there, but if there isn't something it isn't at all obvious.