PmodTPH Reference Manual
The Digilent PmodTPH (Revision C) offers 6 external pin headers so that users can easily test the signals passing through each of the pins.
Download This Reference Manual
- 6 external test point headers
- Easily access and test signals passing through
- 6-pin Pmod port with GPIO interface
The PmodTPH is a great way for users to get easy access to signals coming in and out of the system board by acting as an intermediate between the system board and the peripheral component.
Interfacing with the Pmod
The PmodTPH is a pass through module, making it essentially equivalent to a set of six wires coming from the system board with center taps that users can attach their multimeter probes to. Consequently, there is no particular protocol that is associated directly with this Pmod.
Pinout Description Table
|5||GND||Power Supply Ground|
|6||VCC||Positive Power Supply|
As there are no integrated circuits on this Pmod, any external power that is usable with the system board can be applied to the PmodTPH.
The pins on the pin header are spaced 100 mil apart. The PCB is 1 inch long on the sides parallel to the pins on the pin header and 0.8 inches long on the sides perpendicular to the pin header.
The schematics of the Pmod TPH are available here.
As the Pmod TPH is a just a pass through module with additional contact points to monitor the signals and does not modify the signals in any way, there is no appropriate code to demonstrate how to use the the Pmod TPH.
If you have any questions or comments about the Pmod TPH, feel free to post them under the appropriate section (“Add-on Boards”) of the Digilent Forum.