Pmod TC1
Buy
Reference Manual
Technical Support
Pmod TC1
K-Type Thermocouple Module with Wire
Features
- K-type thermocouple-to-digital converter
- Wide temperature range of -73°C to 482°C with provided wire
- ±2°C accuracy from -200°C to 700°C
- 14-bit with 0.25°C resolution
- Cold-junction temperature compensation
- 6-pin Pmod port with SPI interface
- Follows the Digilent Pmod Interface Specification Type 2
Electrical
Bus
SPI
Specification Version
1.2.0
Logic Level
3.3V
Physical
Width
1.0 in (2.54 cm)
Length
0.80 in (2.03 cm)
Documentation
Primary IC
Thermocouple wire
Reference Manual
3D Model
J1 Pinout
Pin 1
CS
Pin 2
NC
Pin 3
MISO
Pin 4
SCLK
Pin 5
GND
Pin 6
VCC
The Digilent Pmod TC1 (Revision A) is a cold-junction thermocouple-to-digital converter module designed for a classic K-Type thermocouple wire. With Maxim Integrated's MAX31855, this module reports the measured temperature in 14-bits with 0.25°C resolution.
Example Projects
Microprocessor
- Mpemba Effect - Community Project
- Reflow Toaster Oven - Community Project
- Plug and Play Pmods Using LabVIEW - Community Project
- Using the Pmod TC1 with Arduino Uno - Application note
Programmable Logic
-
- Digilent Pmod IPs are only supported in Vivado and Xilinx SDK versions 2019.1 and earlier.
Additional Resources
- Specification Version 1.2.0: PDF