Pmod CON3
Buy
Reference Manual
Technical Support
Pmod CON3
R/C Servo Connectors
Features
- Four standard 3-wire servo motor connectors
- Easily interface with Digilent system boards
- Flexible power delivery to servos
- 6-pin Pmod port with GPIO interface
- Follows the Digilent Pmod Interface Specification Type 1
Electrical
Bus
GPIO
Specification Version
1.2.0
Logic Level
3.3V
Physical
Width
1.0 in (2.54 cm)
Length
0.80 in (2.03 cm)
J1 Pinout
Pin 1
P1
Pin 2
P2
Pin 3
P3
Pin 4
P4
Pin 5
GND
Pin 6
VCC
The Digilent Pmod CON3 (Revision C) can be used to easily interface with up to four small servo motors that deliver anywhere from 50 to 300 ounce/inches of torque such as those used in radio controlled airplanes or cars as well as some mechatronics projects.
Example Projects
Programmable Logic
- Line Following SRK Robot with 3D printed parts - Community Project
- Using the PmodCON3 with chipKIT products - Community Project
- Controlling Servos via Bluetooth (RN-42) and LabVIEW - Community Project
Reference Projects
- Setting Up the Zybot - Hardware - Community Project
- Setting up the Zybot - Hardware Round and Tall Edition - Community Project
- Controlling Servos on FPGA - Community Project
Additional Resources
- Specification Version 1.2.0: PDF