Pmod CLS
Buy
Reference Manual
Technical Support
Pmod CLS
Character LCD with Serial Interface
Features
- 16×2 liquid crystal character display
- Wide range of instruction functions
- Up to 32 user definable characters
- Multiple communication options including UART, SPI, and I²C
- Two 1×6-pin Pmod ports with SPI and UART interfaces
Electrical
Bus
SPI, UART, I²C
Specification Version
Legacy Pmod
Logic Level
3.3V
Physical
Width
1.8 in (4.6 cm)
Length
3.8 in (9.7 cm)
J1 Pinout
Pin 1
SS
Pin 2
MOSI
Pin 3
MISO
Pin 4
SCK
Pin 5
GND
Pin 6
VCC
J2 Pinout
Pin 1
SCL
Pin 2
SDA
Pin 3
TXD
Pin 4
RXD
Pin 5
GND
Pin 6
VCC
The Digilent Pmod CLS (Revision E) is a 16×2 character LCD module driven by Atmel's ATmega48 microcontroller.
Example Projects
Microprocessor
- Heart Rate Monitor Using a Photoresistor - Community Project
- ChipKIT Parking Obstacle Sensor - Community Project
- Using the Pmod CLS with Arduino Uno - Application note
Programmable Logic
- Arty A7 100T project using the Pmod ACL2, Pmod CLS, and Pmod 7SD created by user Tim S. on the Digilent Forum Forum thread
- Arty A7 100T project using the Pmod SF3 and Pmod CLS created by user Tim S. on the Digilent Forum Forum thread
- Zybo Z7-20 project using the Pmod SF3 and Pmod CLS created by user Tim S. on the Digilent Forum Forum thread
-
- Digilent Pmod IPs are only supported in Vivado and Xilinx SDK versions 2019.1 and earlier.