====== OpenScope MZ Hardware Change Log ======

==== Rev F ====
----
Initial Release.

==== Rev G ====
----
  - 200 ohm protection resistors on all LA (PORTE) pins
  - D-Flip/Flop to tie the FTDI clock to the MZ
    - To enable potential increased baud rates (above 1.25 Mbaud) in future firmware / software updates.
  - No Load of the power jumper (JP3) and a cutable trace on the power
  - Changed the 1uF Cap on the MRF24 (805) to a 10uF cap
    - Add bulk capacitance to 3v3 rail to better handle inrush current.
  - Added a 10uF cap (603) on the uSD card
    - To avoid potential voltage drop when an out of spec SD card is inserted.
  - Updated Rev and date