~~NOTOC~~ 
   
====== Pmod TMP3 ======

  
{{Digilent Infobox
| Store Page = https://digilent.com/shop/pmod-tmp3-digital-temperature-sensor/
| Manual = [[reference-manual]]
| Support = https://forum.digilent.com/forum/7-add-on-boards/
| Title = Pmod TMP3
| Subtitle = Temperature Sensor
| Header = Features
| Bullet = Ambient temperature sensor with up to 12-bit resolution
| Bullet = Typical accuracy of ±1 °C
| Bullet = Programmable temperature alert pin
| Bullet = Multiple jumpers for eight selectable addresses
| Bullet = 30 ms to 240 ms typical conversion times
| Bullet = 2×4-pin port with I2C interface
| Bullet = Follows the Digilent {{/reference/pmod/digilent-pmod-interface-specification.pdf |Pmod Interface Specification}}
| Header = Electrical
| Bus = [[learn/fundamentals/communication-protocols/i2c/start | I²C]]
| Specification Version = 1.0
| Logic Level = 3.3V
| Header = Physical
| Width = 1.0 in (2.54 cm)
| Length = 0.80 in (2.03 cm)
| Header = Design Resources
| Fritzing Part = {{reference:pmod:pmodtmp3:pmodtmp3.fzpz| }}
| Header = Documentation
| Primary IC = [[http://www.microchip.com/wwwproducts/Devices.aspx?product=TCN75A | TCN75A]]
| Reference Manual = [[pmod/pmodtmp3/reference-manual]]
| Schematic = {{reference:pmod:pmodtmp3:pmodtmp3_sch.pdf| }}
| Header = J1 Pinout
| Full Row = {{ :reference:pmod:pmod-pinout-2x4.png?direct |}}
| Pin 1 & 5 = SCL
| Pin 2 & 6 = SDA
| Pin 3 & 7 = GND
| Pin 4 & 8 = 3V3
| Header = J2 Pinout
| Pin 1 = AL
| Pin 2 = GND
}}

{{page>reference-manual}} \\ \\
 


===== Example Projects =====

==Microprocessor==
  * [[learn/software/tutorials/digilent-core-install/start | Installing the Digilent Core for Arduino]]
  * {{:reference:pmod:pmodtmp3:pmodtmp3_mpide.zip|Library and MPIDE Example}}
  * {{:reference:pmod:pmodtmp3:pmodtmp3_arduino.zip|Arduino IDE with chipKIT Core Example}}
  * [[http://www.instructables.com/id/Plug-and-Play-Pmods-Using-LabVIEW/step4/LabVIEW-Code/|Plug and Play Pmods Using LabVIEW]] - Community Project
  * [[https://www.hackster.io/mmigs/using-the-pmod-tmp3-with-arduino-uno-ba0de9|Using the Pmod TMP3 with Arduino Uno]] - Application note
==Programmable Logic==
  * [[learn/programmable-logic/tutorials/pmod-ips/start | Getting Started with Digilent Pmod IPs]]
     * Digilent Pmod IPs are only supported in Vivado and Xilinx SDK versions 2019.1 and earlier.

----

===== Additional Resources =====
  * Specification Version 1: {{https://www.digilentinc.com/Pmods/Digilent-Pmod_%20Interface_Specification.pdf |PDF}}

----

{{tag>pmod pmod-start pmod-i2c pmodtmp3 temperature-sensor resource-center}}