~~NOTOC~~ 
   
====== Pmod PMON1  ======
  
{{Digilent Infobox
| Store Page = https://digilent.com/shop/pmod-pmon1-power-monitor/
| Manual = [[reference-manual]]
| Support = https://forum.digilent.com/forum/7-add-on-boards/
| Title = Pmod PMON1
| Subtitle = Power Monitor
| Header = Features
| Bullet = Monitor current draw less than 1.058 A
| Bullet = Wide range of configurable alert conditions
| Bullet = Monitor voltages from 3.16 V to 26 V
| Bullet = Configurable device address for up to nine modules in a single system
| Bullet = 2×4-pin connector with I2C interface
| Bullet = Follows the Digilent {{/reference/pmod/digilent-pmod-interface-specification.pdf |Pmod Interface Specification}}
| Header = Electrical
| Bus = [[learn/fundamentals/communication-protocols/i2c/start | I²C]]
| Specification Version = 1.0
| Logic Level = 3.3V
| Header = Physical
| Width = 1.2 in (3.05 cm)
| Length = 0.80 in (2.03 cm)
| Header = Design Resources
| Fritzing Part = {{reference:pmod:pmodpmon1:pmodpmon1.fzpz| }}
| Header = Documentation
| Primary IC = [[http://www.analog.com/AD5112 | AD5112]], [[http://www.analog.com/ADM1191 | ADM1191]]
| Reference Manual = [[pmod/pmodpmon1/reference-manual]]
| Schematic = {{reference:pmod:pmodpmon1:pmodpmon1_sch.pdf| }}
| Header = J1 Pinout
| Pin 1 & 2 = CONV
| Pin 3 & 4 = ALERT
| Header = J2 Pinout
| Full Row = {{ :reference:pmod:pmod-pinout-2x4.png?direct |}}
| Pin 1 & 2 = SCL
| Pin 3 & 4 = SDA
| Pin 5 & 6 = GND
| Pin 7 & 8 = DVDD
| Header = J3 Pinout
| Pin 1 = VIN
| Pin 2 = GND
| Pin 3 = VOUT
}}

{{page>reference-manual}} \\ \\
 
===== Example Projects =====

  * No programmable logic example projects are available for the Pmod PMON1



----

===== Additional Resources =====
  * Specification Version 1.0: {{https://www.digilentinc.com/Pmods/Digilent-Pmod_%20Interface_Specification.pdf |PDF}}

----

{{tag>pmod pmod-start pmod-i2c pmodpmon1 power-monitor resource-center}}