~~NOTOC~~ 
   
====== Pmod OD1  ======
  
{{Digilent Infobox
| Manual = [[reference-manual]]
| Support = https://forum.digilent.com/forum/7-add-on-boards/
| Title = Pmod OD1
| Subtitle = Open Drain Output
| Header = Features
| Bullet = Two dual power N-FETs
| Bullet = Comfortable drives 3.0 A of continuous current
| Bullet = 4.1 A peak output current (t < 5 s)
| Bullet = 20V maximum output voltage
| Bullet = Four output clamp diodes
| Bullet = 6-pin Pmod connector with GPIO interface
| Bullet = Follows the Digilent {{/reference/pmod/digilent-pmod-interface-specification.pdf |Pmod Interface Specification}} Type 1
| Header = Electrical
| Bus = [[learn/fundamentals/communication-protocols/gpio/start | GPIO]]
| Specification Version = 1.2.0
| Logic Level = 3.3V
| Header = Physical
| Width = 1.15 in (2.92 cm)
| Length = 0.80 in (2.03 cm)
| Header = Design Resources
| Fritzing Part = {{reference:pmod:pmodod1:pmodod1.fzpz| }}
| Header = Documentation
| Primary IC = [[http://www.onsemi.com/pub_link/Collateral/NTHD4508N-D.PDF | NTHD4508]]
| Reference Manual = [[pmod/pmodod1/reference-manual]]
| Schematic = {{reference:pmod:pmodod1:pmodod1_sch.pdf| }}
| Header = J1 Pinout
| Full Row = {{ :reference:pmod:pmod-pinout-1x6.png?direct |}}
| Pin 1 = G1
| Pin 2 = G2
| Pin 3 = G3
| Pin 4 = G4
| Pin 5 = GND
| Pin 6 = VCC
}}

{{page>reference-manual}} \\ \\


===== Example Projects =====


== Microprocessor==
  * [[https://www.hackster.io/mmigs/using-the-pmod-od1-with-arduino-uno-ba405b|Using the Pmod OD1 with Arduino Uno]] - Application note

== Programmable Logic ==
  * No programmable logic example projects are available for the Pmod OD1

----

===== Additional Resources =====
  * Specification Version 1.2.0: {{reference/pmod/pmod-interface-specification-1_2_0.pdf |PDF}}

----

{{tag>legacy pmod pmod-start pmod-gpio pmodod1 open-drain-output resource-center}}