~~NOTOC~~ 
   
====== Pmod OC1  ======
  
{{Digilent Infobox
| Store Page = https://digilent.com/shop/pmod-oc1-open-collector-output/
| Manual = [[reference-manual]]
| Support = https://forum.digilent.com/forum/7-add-on-boards/
| Title = Pmod OC1
| Subtitle = Open Collector Output
| Header = Features
| Bullet = Four 100mA (200mA max) transistors
| Bullet = Four output clamp diodes
| Bullet = 40V voltage threshold
| Bullet = 6-pin Pmod port with GPIO interface
| Bullet = Follows the Digilent {{/reference/pmod/digilent-pmod-interface-specification.pdf |Pmod Interface Specification}} Type 1
| Header = Electrical
| Bus = [[learn/fundamentals/communication-protocols/gpio/start | GPIO]]
| Specification Version = 1.2.0
| Logic Level = 3.3V
| Header = Physical
| Width = 1.0 in (2.54 cm)
| Length = 0.80 in (2.03 cm)
| Header = Design Resources
| Fritzing Part = {{reference:pmod:pmodoc1:pmodoc1.fzpz| Fritzing part }}
| Header = Documentation
| Primary IC = [[https://www.onsemi.com/pdf/datasheet/mmbt3904lt1-d.pdf | MMBT3904]]
| Reference Manual = [[pmod/pmodoc1/reference-manual]]
| Schematic = {{reference:pmod:pmodoc1:pmodoc1_sch.pdf| Schematic }}
| Header = J1 Pinout
| Full Row = {{ :reference:pmod:pmod-pinout-1x6.png?direct |}}
| Pin 1 = P1
| Pin 2 = P2
| Pin 3 = P3
| Pin 4 = P4
| Pin 5 = GND
| Pin 6 = VCC
}}

{{page>reference-manual}} \\ \\
 


===== Example Projects =====

== Microprocessor==
  * [[https://www.hackster.io/mmigs/using-the-pmod-oc1-with-arduino-uno-ac6e7a|Using the Pmod OC1 with Arduino Uno]] - Application note

== Programmable Logic== 
  * No programmable logic example projects are available for the Pmod NIC100



==Reference Projects==
  * {{:reference:pmod:pmodoc1:pmodoc1_demo.zip|Reference Design using the X-Board}}

----

===== Additional Resources =====
  * Specification Version 1.2.0: {{reference/pmod/pmod-interface-specification-1_2_0.pdf |PDF}}

----

{{tag>pmod pmod-start pmod-gpio pmodoc1 open-collector bjts resource-center}}