~~NOTOC~~ 
   
====== Pmod HB3 ======

  
{{Digilent Infobox
| Manual = [[reference-manual]]
| Support = https://forum.digilent.com/forum/7-add-on-boards/
| Title = Pmod HB3
| Subtitle = H-bridge Driver with Feedback Inputs
| Header = Features
| Bullet = 2A H-bridge circuit
| Bullet = Drive a DC motor with operation voltage up to 12V
| Bullet = Screw terminal blocks for connection to the motor
| Bullet = Separate header for external motor feedback
| Bullet = 6-pin Pmod port with GPIO interface
| Bullet = Follows the Digilent {{/reference/pmod/digilent-pmod-interface-specification.pdf |Pmod Interface Specification}} Type 5
| Header = Electrical
| Bus = [[learn/fundamentals/communication-protocols/spi/start | SPI]]
| Specification Version = 1.2.0
| Logic Level = 3.3V
| Header = Physical
| Width = 1.2 in (3.05 cm)
| Length = 0.80 in (2.03 cm)
| Header = Design Resources
| Fritzing Part = {{reference:pmod:pmodhb3:pmodhb3.fzpz| }}
| Header = Documentation
| Reference Manual = [[pmod/pmodhb3/reference-manual]]
| Schematic = {{reference:pmod:pmodhb3:pmodhb3_sch.pdf| }}
| Header = J1 Pinout
| Full Row = {{ :reference:pmod:pmod-pinout-1x6.png?direct |}}
| Pin 1 = DIR
| Pin 2 = EN
| Pin 3 = SA
| Pin 4 = SB
| Pin 5 = GND
| Pin 6 = VCC
}}

{{page>reference-manual}} \\ \\
 
===== Example Projects =====

== Microprocessor==
  * [[https://www.hackster.io/mmigs/using-the-pmod-hb3-with-arduino-uno-b88a9d|Using the Pmod HB3 with Arduino Uno]] - Application note

==Programmable Logic==
  * {{:reference:pmod:pmodhb3:pmodhb3_demo.zip|X-Board VHDL Example}}


----

===== Additional Resources =====
  * Specification Version 1.2.0: {{reference/pmod/pmod-interface-specification-1_2_0.pdf |PDF}}

----

{{tag>pmod pmod-start pmod-gpio pmodhb3 h-bridge resource-center}}