====== Pmod CON4 Reference Manual ======

<WRAP center round important 60%>
The Pmod CON4 is retired and no longer for sale in our store. 
</WRAP>

The Digilent Pmod CON4 (Revision B) allows users to act as a transceiver with two RCA audio jacks.

{{Digilent Image Gallery 
| image = {{:reference:pmod:pmodcon4:pmodcon4-0.png?direct |}}
| image = {{:reference:pmod:pmodcon4:pmodcon4-1.png?direct |}}
| image = {{:reference:pmod:pmodcon4:pmodcon4-2.png?direct |}}
| image = {{:reference:pmod:pmodcon4:pmodcon4-3.png?direct |}}
}} 

== Download This Reference Manual == 
  * {{:reference:pmod:pmodcon4:pmodcon4_rm.pdf| PDF}}

----

===== Features =====
  * 2 RCA audio jacks
  * Receive and transmit audio signals
  * Jumper blocks to easily adjust signal routing
  * 6-pin Pmod connector with %%GPIO%% interface

----
=====Functional Description =====
The Pmod CON4 is able to route any [[pmod:communication_protocols:gpio|GPIO]] based audio signal from one of its four input pins (pins 1 through 4 on the 1x6 pin header) to either one of the RCA audio jacks via the jumper block present on each of the inputs.

----
===== Interfacing with the Pmod=====
The Pmod CON4 is able to both receive and transmit audio (or other) signals to one of the two RCA jacks. However, only one input/output pin can be attached to an RCA audio jack at a time. If two or more are tied to the same jack, there is a chance that one output will be at a high voltage and the other output at a low voltage, effectively shorting those two pins and potentially damaging the system board.

{{ :pmod:pmod:con4:temp2.png?250|}}
^  Table 1: Pin Descriptions as labeled on the Pmod  |||||
^  Header J1  || ^  Jumper Headers  ||
^  Pin Number  ^  Description  |:::^  Jumper Settings  ^  Description  |
|  1  |  Input P1  |:::|  J2  |  The J2 RCA jack will receive this input  |
|  2  |  Input P2  |:::|  J3  |  The J3 RCA jack will receive this input  |
|  3  |  Input P3  |:::|||
|  4  |  Input P4  |:::|||
|  5  |  Ground  |:::|||
|  6  |  Not Connected  |:::|||

Since RCA jacks typically send or receive analog voltage signals, users can easily connect the Pmod CON4 to either an ADC or DAC module such as the [[pmod:pmod:ad5|PmodAD5]] or the [[pmod:pmod:da4|PmodDA4]].
----
===== Physical Dimensions =====
The pins on the pin header are spaced 100 mil apart. The PCB is 1.10 inches long on the sides parallel to the pins on the pin header and 0.8 inches long on the sides perpendicular to the pin header.
----
===== Additional Information =====
The schematics of the Pmod CON4 are available {{:reference:pmod:pmodcon4:PmodCON4_sch.pdf|here}}.

Example code demonstrating how to get information from the Pmod CON4 can be found [[pmod:pmodcon4:start#example_projects|here]]. 

If you have any questions or comments about the Pmod CON4, feel free to post them under the appropriate section ("Add-on Boards") of the [[https://forum.digilent.com/|Digilent Forum]].